You can achieve a lustrous, smooth surface without using specialized tools or spray equipment. Just follow these easy steps.
Advertisement
102141244.jpg

Prepare your workpiece

A glass-smooth finish begins with a level, even surface. To achieve this on open-grain woods (oak, ash, walnut, or mahogany, for instance), first fill the pores with a wood-grain filler, photo below.

102138712.jpg

Scrape off the excess and let dry. Sand the workpiece to 220 grit.

Apply stain and poly

Move to a low-dust setting: somewhere without lots of foot traffic and with dust-free surfaces. You can create such an area by hanging an inexpensive vinyl shower curtain in a corner of your shop. With your workpiece wiped clean, apply stain, photo below. (Skip the stain if you intend to leave your workpiece natural-color.) Let dry.

Staining board
Apply an even coat of stain to your workpiece, making long brushstrokes and overlapping the edges for full coverage. Wipe off any excess stain.

Prepare the polyurethane by reducing it about 10 percent with mineral spirits, unless you're using water-based polyurethane, which doesn't need thinning. Thinning the polyurethane makes it flow on more smoothly and reduces brush marks.

Brush on three thin coats with a foam brush. (You can use a natural bristle brush with oil-based poly, but keep an eye out for loose brush hairs.) Coat the entirety of your workpiece, but don't brush excessively or you'll create areas with too little polyurethane. Allow each coat to dry fully. To give the subsequent poly layers something to bond to, sand lightly between coats with 320-grit sandpaper wrapped around a hard block. Note: The first coat needs the most sanding to appear smooth; don't worry if it doesn't look as flawless as you'd like at first.

After the third coat, sand with 320-grit, then 400-, and finally 600-grit sandpaper. Sand in alternating directions with each abrasive to make it easier to see whether you've removed the scratches from the previous grit. Sand with the grain on the final pass. Then, wipe off the dust with a rag dipped in mineral spirits.

Put on the polish

The final coat gives your workpiece its smooth feel and flawless appearance, so give it extra attention. Spray on this coat using an aerosol polyurethane and let it cure overnight, photo below.

Spraying board
Hold the spray nozzle 12–16" from the workpiece and sweep the can across the surface without stopping. Apply only one thin coat.

Then, remove any dust nibs with 1,500-grit sandpaper or a piece of brown paper bag. Finally, using a soft cotton rag or polishing pad, buff the finish to a high shine using automotive paste wax, photo below, which has fine abrasives that polish the finish even further.

Buff pad on board
Apply a small amount ofautomotive paste wax, workingin the grain direction to hide finescratches. Buff off the excess witha clean, soft rag.